Welding Guage

• Measures internal alignment of pipe after fit-up/alignment, cuts radiographic rejects
• Measures internal misalignment of pipe before and after tracking
• Measurements read in standard on one side and metric on the opposite side

Technical Details :

• Changes from standard to Metric , simply remove gauge body , turn scales over and replace body
• Measurements read Metric on one side and Standard on the other side
• Measures internal alignment of the pipe after fit up /alignments . and rejects radiographic rejects
• Measures internal misalignment of pipe before and after tacking
• Measures bevel on end preparation

• Angle of Preparation, 0º to 60º
• Excess Weld Metal (capping size)
• Depth of Undercut
• Depth of Pitting
• Fillet Weld Throat Size
• Fillet Weld Length
• Misalignment (High-Low)

Filet weld gauges measures fast and accurate measurement of 11 fillet weld sizes.

Blades are deburred to remove rough edges

All sizes are engraved for easier and better reading

Gauge blade must be flush to the base with Tip touching the vertical member. Use the single are corners for measuring convex welds. Use the double arc corners if the welds are concave ( Undersize ) /If they are  more filler material is required to build weld throat to the size where the tip between the double arcs touch.

Convex Weld: Place single arc edge flush to base material so blade tip touches vertical member the weld size is indicated

Concave Weld: Place double arc Flush to base material so tip touches vertical member. If the tip between the double arc touches the centre of the weld   the weld is the profile desired and is the size indicated

Product Details:

• MM: inch/ metric conversion
• ON/OFF: power on and power off
• ZERO: zero setting
• Power: 1.5V SR44 (sliver oxide cell)
• Via data connecting cable

Product Details:

• Type - Weld Gauge
• Size - Customised
• Applications - Welding  

• Check Reinforcement
• Check the Throat of Fillet Weld
• Determine the Leg Size of the Fillet Weld

* Stainless steel 
* Satin chromed finish 
* Suitable to inspect flat welded seams and corners 
* For angle 60 deg; , 70 deg; , 80 deg; , 90 deg; 
* Packed in semi-leather pouch.